Issue with rise of the primes red and 7tsp

**Saintzer0** · February 5th, 2012 05:50 AM

The 7tsp file fo Rise of the Primes red will not patch. It just "checks the situation" forever. I let it run for at least 30 minutes but nothing happens at all.

The file is not unpacked By the way

**gor17981** · February 5th, 2012 06:11 AM

Add 7_tsp to the beginning of the file name, like this

that should work

**Saintzer0** · February 5th, 2012 12:04 PM

I added the 7_tsp to the beginning of the file but 7tsp is still saying checking out current situation.

do I need the no topshell version for this to work?

**Oshea** · February 5th, 2012 02:15 PM

Hey Saintzer0,
Im curious, have you used 7tsp before. By that I mean, have you installed other packs in the past?
I only ask because 7tsp will want to create a restore point before installation. So you need to have your system protection set to ON before it can do so.
Also, in your pic I noticed that the logon, side panel, and start orb were checked... Did you check these? I dont believe any of those are included in this pack, and Ive had issues in the past with asking 7tsp to sort of 'multitask' in the process of installing a pack for me.
Perhaps try unchecking these and see what the result is...
I hope this helps you out, man... Thats a great pack....

**2635599** · February 5th, 2012 02:16 PM

i noticed the file says x 86 and x 64. i just checked mine and it says x64. i'm wondering if this is one where the actually 7tsp file you want is inside that archive. i honestly remember, cause if it was i would of ectracted what i needed and deleted the rest. open the archive with winrar or 7-zip and see if there are any .7z files in it. if so extract them.

Oshea, if system restore is turned off all 7tsp will do is tell you it can't make a restore point, then continue the install.

Saintzer0, just noticed your file name on that and it's like mine is. try rightclicking 7tsp and running as admin, then go to file and select your .7z file. i have the exact same version downloaded. i haven't installed it yet. i'll created a rollback snapshot, then install it to see if i have any problems with it. givbe me a few minutes.