Results 1 to 6 of 6
Thread: PSU Shroud mod For NZXT Phantom
Threaded View
-
January 28th, 2013 09:40 PM #5
- Join Date
- Apr 2011
- Location
- At The Pc "wishing I could upload myself"
- Posts
- 49
- Mentioned
- 2 Post(s)
- Tagged
- 0 Thread(s)
- Sex:
Nice going for a 1st attempt, What I found when trying to bend metal in a tight angle is it is best to use 2 pieces of right angle metal that are slightly longer then what you are trying to bend and then nut and bolt both end just past the metal so that you get a nice tight clamp then use a thick piece of wood and just hammer it along the wood going back and forth. It takes a little bit of time but it works out quite nice.
I came across someone modding a side panel that they needed to get the engraved pattern to light up what they did was drilled some small holes around the edge of the plexiglass and then put led's inside the holes which made it light up really well, not sure if it will help with what you want to do but it might.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Phantom wallpaper
By The Archiver in forum Wallpapers Posted by The ArchiverReplies: 9Last Post: April 28th, 2020, 01:56 AM -
A New Carbon Fiber Psu Shroud And Haf 932 Mod Build Log
By odinlives in forum Overclocking & Mod RigsReplies: 34Last Post: May 27th, 2012, 03:30 PM
Update - July 2, 2024 New discord server created to make up for the old being shut down Post updated with the new link and details
Unofficial Discord Server